Home
- Xapt3r 1.6 Solderless Adapter Install
Xapt3r 1.6 Install
- The first thing to do is to take your Xbox apart.

Using a Torx 20 Screwdriver, unscrew the 6 screws and remove the top cover. |

Using a Torx 10 Screwdriver, unscrew the 3 screws and remove the DVD ROM & Hard Drive units. Unplug the grey IDE cable and yellow power cable from the motherboard. |
- This is the section of the board where the Xapt3r 1.6 will go.
- Screw in the Xapt3r. Insert the 5 wires in to holes A, B, C, D and E. Lastly hook the 5v wire on to the leg as shown.

- This is how it looks with the Xapt3r 1.6 in position.

- Now put the chip onto the Xapt3r.
- Now for the test. There is no need to connect your DVD Rom or Hard Disc to test if you install is correct.
- IMPORTANT: You must have the switch plugged in and the chip enabled to do this test. Plug in the power to the Xbox and turn on. You should have a blue LED on the chip and the FlashBIOS Cromwell bios screen. If you see this screen that's it you've done it - well done. You should make sure the switch is working correctly. Disable the mod and the LED should turn red - now power cycle the Xbox - it should boot to the default Microsoft start-up (green flubber / X logo etc).

- The last thing to do is to get the switch bank in the correct position. Once you've done this, put the DVD drive and hard drive back in place and screw it all back together.

This site and all contents are ©2010 Kanection Online Email: mail@kanection.co.uk Telephone: 0845 456 1144

|